3


PTMA parts
240 Volt power lead
Connects the external power supply to the mains.  13 amp mains plug (fitted with a 3 amp fuse) with a standard IEC connector at the power supply end.
9 Volt power lead
Connects external power supply to external speed controller.  One 3.5mm mono phono plugs at each end of the lead, so it is completely reversible.  The tip carries the nine volt supply, the sleeve carries the zero volt return.  If you have a combined power supply and speed controller unit, this lead will not be needed or supplied.

motor control lead
Motor control lead
Connects the external speed controller to the PTMA turntable. One seven pin DIN plug at each end of the lead, so it is completely reversible.  For details of the pin connections, consult the PTMA construction and assembly instructions. If you have the speed controller built into the turntable plinth, this lead will not be needed or supplied

vector pulleys
Vector pulleys
These will be supplied if you have selected the vector option.
Turntable adjustable feet
Tthese will be supplied if you have selected the adjustable feet option.
Turntable lid
This is fitted to the turntable when packed
Turntable top plate
This will be at the top of the box, covered in a white protective film top and bottom as illustrated.
plinth with transit bar
Turntable plinth
The MDF plank is the transit bar which holds the subchassis steady, and should be fitted when the turntable is packed.  The transit bar is fixed onto the subchassis with a M5 bolt; a 4mm allen key is supplied for this bolt and the armboard bolts.

plinth and parts
Parts and tools
These are in plastic bags fastened to the transit bar.  The parts are detailed in the next section
Platter, bearing and belt
These are packed under the turntable plinth
External power supply
If supplied it comes packed in a second, smaller box.
External speed controller
If supplied it comes packed in a second, smaller box.